|
|
| Now
we'll fabricate a template that will bolt to the motor
mount holes on the block of the Ford engine.
A duplicate for the other side will be made and we'll
fabricate the motor mounts using these plates. |
|
|
|
| The
driver's side plate is bolted to the block. |
|
|
|
| Here's
the backside of the firewall showing the transmission. All
the metal flooring will be removed and replaced once the
firewall is welded in. |
|
|
|
| With
the body removed, we can weld up the new motor mounts and
transmission mount. |
|
|
|
| Here's
the tube motor mounts we fabricated to hold the engine in
place. |
|
|
|
| Here's
a front picture of the frame with the engine in place. |
|
|
|
| This
picture shows the drop out transmission mount. |
|
|
|
| The
rearend has been placed on the springs and the pinion
angle set. Next we'll install the shock mounts. |
|
|
|
| This
rear shock crossmember is being positioned in the chassis. |
|
|
|
Page 1
2 3 4
Next-->
|
|
|
