|
|
| The
rocker that runs below the hood sides needs to be fitted
to flow into the Redneck body. The Viper front end was
designed to fit a Viper body so we're having to adapt it
to fit a standard '34 body. |
|
|
|
| The
work on the front of the hood has begun. When the shaping
is finished, it will fit the contour of the grille shell
perfectly. |
|
|
|
| Charles
has been working on fitting the lower rocker to the body.
He trimmed it and cut a slit in the body and widened it to allow a
seamless transition into the front of the body. |
|
|
|
| The
front of the rocker is roughed in and attached to the Viper
grille shell. |
|
|
|
| The
front of the hood is looking good. A little more massaging
and it'll be right. |
|
|
|
| After
splitting, the V section is fiberglassed from the front
and back side. |
|
|
|
| The
same work is performed on the driver's side of the
body. |
|
|
|
| The
back of the hood needed a little more fiberglass added to
get the gap right. |
|
|
