Tom Johnson's '41 Willys

Tom Johnson's '41 Willys

Construction Pictorial

Page: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

This gives you a better view of the front mounting of the roll bar.

This roll bar was fabricated to be taken apart, so the upholstery could be done and we could powder coat the roll bar.

All the welding has been finished and it waits to be taken to Advanced Plating in Nashville, TN for the powder coating.

This is the hole that was left after the roll bar was removed.

So we did not have a hole that was going to throw water in the car we fiber glassed some pockets.

This is a trial fit of one of the pockets.

We dura bonded the pocket.

This is the front pocket on the passenger side, it almost gets into the rocker.

Here is the drivers side.

Both pockets have been dura glassed and also the gap in the floor has been fiberglassed.

Page: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25