Because
of the large center section of the rear end, the
trunk had to be cut to clear it. Here you can
see the fiberglass hump we're installing in the
trunk area.
Here's
a front shot of the hump.
Underneath
the car the hump is ready to be molded into the
body.
To
give Jeff some more leg room, the tunnel has
been kicked outward a bit.
Here's
an inside look at the kickout. This section will
give Jeff more foot room on the gas pedal.
Meanwhile
over at the paint shop the hood sides are being
buffed out.
Here's
one of the rear fenders being sanded and buffed.
Here's
Chad buffing out the driver's side rear fender.
And
the passenger side rear fender.
Here's
the dash all painted up to match.
The
hood and trunk lid have been painted and buffed.
The next step is to clear coat them.
