Dennis Wargo's '32 Ford Three Window

Dennis Wargo's '32 Ford Three Window

Page 1 2 3 4 5 6 7 8 9 10 11 12 13

Johnathan gets the top 4-Bar bracket holes to the correct diameter by using a unibit.

The rear four bars are in place and the brackets tacked.

The front suspension is almost finished. The disc brakes are on and the shocks mounted up.

The 9" Ford center section is installed, and the axles and brakes are in. The chrome and polished rear shocks are also in place.

Check out this cool new product from Pete and Jakes for Hi-Boys. A combination shock mount and headlight mount!

The wheels and tires are on and the chassis is rolling. The next step will be to run the brake lines and the body can be reinstalled.

Johnathan sets the body back on briefly to make sure everything is lining up ok.

Here's a rear shot with the body on.

Our plastic big block is being positioned to install the motor mounts in the chassis.

Peeking through the tunnel, we see the Lakewood scatter shield and the 4 speed transmission.

Page 1 2 3 4 5 6 7 8 9 10 11 12 13