Return to Page 1 Go to Page 3
Jaysun is using an air chisel to remove the leftover metal on the inner rocker.
Most of the sheet metal has been removed.
Here's a picture of the torque tube and tranny brace.
Here's the floor before we started preparing it for the install.
We punched holes in the floor to be re-spot welded.
The paint was ground off of the floor board so it wouldn't contaminate the weld.
We re-sprayed the edges with weld-through primer where the paint was ground off so there wouldn't be a rust build up.
Floor is installed.
To see the HEIDT'S PRO-G Front Suspension Installation on Slingblade go to Page 3