Return to page 1 Go to page 3
The front is notched and ready for the steering rack.
Steering rack installed.
Another look from a different angle.
Mocking the steering joint to check for clearance.
In order to use a sway bar we had to use a 1/4'' piece of steel to give us the thickness to tap and hold the sway bar.
All welded up ready to be smoothed out.
Ground smooth, like it was never there.
Sway bar mounted in place.
Center crossmember installed.
Time to C notch the rear-end.
C notch cut out and welded up.
C notch ground smooth and rear-end getting ready to be installed.
All rear-end housing brackets are welded in place.
Frame is all done and here's a view of the front end.
Here is a nice view of the center crossmember.
A look at the rear-end.
A nice side view of frame all done.
Fitting the viper front-end in place.
After the front end has been fitted we use allen head bolts to hold the front end in place.
Here's another look from the other side.
Click here to go to next page.