|

Click For
Bigger Picture
Click
Here For Dimensions
|
High Mount Air Compressor Bracket
This bracket is designed
to be used with the factory alternator mount. The
compressor belt runs with in the factory A/C groove and the
bracket is complete with idler assembly.
Air Compressor Bracket #116L -
$85.00
|
|
|

Click For
Bigger Picture
Click
Here For Dimensions
|
Low Profile Vette/Camaro
Engineered for low hood applications on any vehicle with a
wide engine compartment. Trucks, 50-60's cars etc. Bolts to the
heads and water pump. Will work with factory power
steering pump.
Air Compressor Bracket #122R - $85.00

Alternator Bracket #222L - $85.00

|
|
|

Click For
Bigger Picture
Click
Here For Dimensions
|
Low Profile Vette/Camaro Air
Compressor Bracket
This bracket is designed
for cars with low hood clearance-Camaros, Chevelles, etc.
Works with any vehicle with wide engine compartment. Bolts to
head and water pump. Works with factory alternator and
power steering pump.
Air Compressor Bracket #122L - $85.00
|
|
|

Click For
Bigger Picture
Click
Here For Dimensions
|
Mid-Mount Alternator Bracket
This bracket mounts the
alternator just above the pump inlet. Bolts to head and
water pump. Works well in low hood applications.
Mid-Mount Alternator Bracket
#225R - $45.00
|
|
|

Click For
Bigger Picture
Click
Here For Dimensions
|
Low Mount Alternator Bracket
This bracket is designed to
mount the alternator low on the driver's side. Bolts to the block
and water pump. Will fit narrow frame applications.
Low Mount Alternator Bracket
#217L - $40.00
|
|
|

Click For Bigger Picture
Click
Here For Dimensions
|
Power Steering
Bracket bolts to the front of the block and water pump boss.
Mounts the pump in approximately the same position as the factory
bracket. Provides clearance for steering gears, etc.
Power Steering Bracket #407L -$65.00 ea.
 |
|
|

Click For Bigger Picture
Click
Here For Dimensions
|
Type 2 Power Steering - Street Rod
This bracket is designed to
be used with the metric GM remote reservoir Type 2 pump.
Designed for street rod applications, it sits high enough to clear
most chassis parts and steering gears. WILL NOT WORK WITH LOW
PROFILE BRACKETS. Pump is driven off the inner groove of a
3-groove crank pulley. Pump uses an aluminum V-belt
pulley.
Type 2 Power Steering Bracket
#414L - $65.00 ea.
|
|
|

Click For Bigger Picture
Click
Here For Dimensions
|
Type 2 Power Steering - Low Profile
This bracket is designed to
be used with the metric GM remote reservoir Type 2 pump.
Designed for low profile applications, it sits low enough to clear
low profile alternator belt. Pump is driven off the inner groove
of a 3 groove crank pulley. Pump used an aluminum V-belt
pulley.
Type 2 Power Steering Bracket
#416L - $65.00 ea.
|