|
|
|
Click
Here For Midnight Series
|
Throttle Cable Bracket &
Spring Kit
SS bracket mounts to rear of
Holley, Edelbrock, AFB, Quadrajet, Demon and In-Line Dual Quads.
SS bracket and GM designed dual stainless springs are used to
mount Lokar's Throttle Cable and Kickdown kits. Designed
to improve clearance on Edelbrock carbs., and includes tension
screw to prevent bracket from movement under extreme pressure on
a kickdown cable, such as with a 700-R4 transmission.
Bracket & Spring Kit - $27.00
Bracket Only - $14.00
Springs Only - $14.00
|
|
|
Click
Here For Midnight Series
|
Tune-Port Brackets
The billet aluminum
bracket mounts to the side of the Tune-Port plenum. This bracket
is available in single stud - throttle use only; double stud -
throttle and kickdown; and triple stud - throttle, kickdown, and
cruise control cables.
Billet Aluminum Tune Port Bracket Single Stud - $37.00
Billet Aluminum Tune Port Bracket Double Stud - $37.00
Billet Aluminum Tune Port Bracket Triple Stud - $37.00
|
|
Polished Tune-Port Brackets
The polished billet
aluminum bracket mounts to the side of the Tune-Port plenum. This
polished bracket is available in single stud - throttle use only;
double stud - throttle and kickdown; and triple stud - throttle,
kickdown, and cruise control cables.
Polished Billet Aluminum Tune Port Bracket Single Stud - $70.00
Polished Billet Aluminum Tune Port Bracket Single Stud - $70.00
Polished Billet Aluminum Tune Port Bracket Single Stud - $70.00
|
|
|
Click
Here For Midnight Series
|
LS1 Bracket
The billet aluminum bracket mounts to the side of the
LS1 manifold and is available with a single stud for throttle
only or double stud to add a cruse control cable.
Billet Aluminum LS1 Throttle Bracket Single Stud '98-'99 GM
Throttle Body
w/3" Linkage Cam - $37.00
Billet Aluminum LS1 Throttle Bracket Double Stud '98-'99 GM
Throttle Body
w/3" Linkage Cam- $37.00
Billet Aluminum LS1 Throttle Bracket Single Stud ''00-'02
GM & '04 GTO Throttle Body
w/3-1/2" Linkage Cam - $37.00
Billet Aluminum LS1 Throttle Bracket Double Stud ''00-'02 GM &
'04 GTO Throttle Body
w/3-1/2" Linkage Cam - $37.00
|
|
|
 
Click
Here For Midnight Series
|
Ramjet Bracket
This stainless steel bracket
fits the GM Ramjet engine and along with the Lokar Throttle
Cable will allow the Ramjet engine to work properly in any
vehicle. When matched up to a automatic transmission be sure to
use one of Lokar's Kickdown Cable for that specific
transmission.
SS Ramjet 350 Throttle Cable
Bracket - $58.00
SS Ramjet 502 Throttle Cable Bracket - $55.00
|
|
|
92 & Later
Cruise
Click
Here For Midnight Series
|
LT1 & LT4 Bracket
Stainless Throttle and
Kickdown Brackets replace the factory brackets to use in
conjunction with Lokar's Throttle and Kickdown Cables. Kit
includes SS arm to mount on LT1 throttle body to operate
kickdown and are designed to be used with Lokar's TPI throttle
and kickdown cables.
'92-'93 LT1 Throttle & Kickdown Cable Brackets - $58.00
'94 & Later LT1 & LT4 Throttle & Kickdown Cable
Brackets - $58.00
'92 & Later LT1 Cruise Control Cable Bracket - $58.00
|
|
|
Click
Here For Midnight Series
|
Tri-Power Bracket & Spring
Kit
Designed for Rochester
Tri-Power kit includes SS throttle cable bracket and SS springs.
Stainless bracket mounts under rear carburetor on Rochester 3-2
set-up. Cables operate from center carburetor and is used to
mount Lokar's throttle and kickdown cables.
SS Tri-Power Throttle Cable Bracket & SS Springs - $44.00
SS Tri-Power Throttle Cable Bracket - $32.00
SS Pontiac Tri-Power Throttle Cable Bracket & SS Springs - $44.00
|
|
|
Click
Here For Midnight Series
|
Ford EFI Bracket
Ford EFI SS Bracket fits
1986 to 1993 Ford 302 and 351 electronic fuel injection systems
that have installed the Mustang EGR spacer. This bracket mounts
in the stock location for easy installation of Lokar's throttle
and kickdown cables. 1986 to 1993 uses the TC-1000HT.
SS EFI Throttle Bracket - $14.00
The EFI Bracket Does Not Fit B.A.P. Throttle Bodies
|
|
